BNC Connectors are radio frequency connectors that are used with coaxial cable.
Applications
With a quick release bayonet connection, BNC connectors were a widely used and reliable standard in RF applications. While most commonly used for allowing televisions to receive analogue signals form terrestrial antennae, the connector was also used in radio and signal test instrumentation and even in early computing hardware.
The Bayonet Neill-Concelman connector is usually used in applications requiring below 4 GHz frequency and below 500 volts, and matches the characteristic impedance of 50 Ohm or 75 Ohm cable.
The RS range of BNC connectors includes plugs, sockets and adapters, as well as gold plated versions for when applications require a higher quality connection.
Description:
A range of RS Pro metal BNC feedthrough
connectors. The rugged 50 Ω and 75 Ω connectors are housed in robust nickel plated zinc XLR shells with universal 23.6 mm diameter panel cut outs. The metal feedthrough connectors are suitable for front or rear panel mounting.Part number 124-6390 50 ΩPart ...
Description:
50 Ohm ZDC/BNC shielded right angle/elbow mount PCB
socket with solder terminal, polyethylene dielectric and nickel plated zinc body. This 50 Ohm ZDC/BNC shielded right angle/elbow mount PCB jack is rear panel mounting with bulkhead, hex nut retention and requires a panel cut-out of 12 x 12.9mm.
Description:
RF Interface=BNC, RF Connector Style=Jack, Connector System=Cable-to-Board, Sealable=No,
Connector & Contact Terminates To=Printed Circuit Board, Port Configuration=Single Port, Number of Positions=1, PCB Mount Orientation=Vertical, Number of Coaxial Contacts=1, Impedance=50 Ω, Body Insulation=Without, Body Material=Zinc, Body Plating Material=Nickel, RF Connector Center Contact Plating Thickness=, RF Connector Center Contact Plating Material=Gold, RF ...
Description:
Brass-bodied connectors with PTFE insulators and beryllium copper
female contacts. The BT 31 types featured on this page are designed for use with data transmission cables. For information regarding appropriate crimp tooling please refer to the Connector/Cable/Tooling Compatibility table at the beginning of this section. Cut-outs are illustrated for respective ...
