Get a grip on pipes in your machinery using this pneumatic fitting from IMI Norgren. It’s a compression type, which means that it’s made up of a threaded body, a tubing nut and a ring-shaped olive. These combined components let you fasten two tubes together to create a tight, leak-free connection. As you can set it up without the need for soldering, you're free from the risk of overheating that could spark up flames in your system.

• Threaded design for quick and tool-free connection
• Brass body resists corrosion for lasting use in damp settings
• Comes complete with nut and olive for hassle-free assembly

• Sprinkler systems
• Pharmaceutical industry
• Wastewater treatment
• Gas plants
• Agricultural equipment

To mount this compression fitting, start by making sure your pipe is clean and cut square. Insert the pipe into the body of the connector and then slip the olive and the nut over it before using a spanner to tighten the nut. This will cause the olive to press down on the outside of the pipe, creating a tight seal.

For compression fittings that can stand up to the harshest conditions, choose from Norgren’s ENOTS series fittings.

The ENOTS compression fittings are ideally suited for most general industrial applications, making them a versatile and dependable choice. These durable fittings are made entirely from extruded brass bar or hot brass stampings, allowing you to use them in extreme pressures and temperatures. Their practical use is only limited by the type of tubing you choose to go with them.

These rugged little units are perfect for helping to keep your air preparation operations airtight and running safely and efficiently for longer.