The MikroElektronika ECG Click Board is an accessory board that provides a simple method of adding electrocardiogram measurement hardware to a development platform.

This starter kit variant provides the required electrodes and cables in addition to the ECG Click Board.

Like all Click Boards the ECG Click fits the popular mikroBUS™ socket, creating a plug-in solution to add functionality, removing the need for hardware configuration.

The ECG Click measures electrical activity of the heart through 3 electrodes taped to the skin that connect to the board via a 3.5mm jack. The circuity of the ECG click amplifies the electrical signals from the heart and filters out noise, providing a clean and clear signal for the mother development board.

The MikroElektronika MikroPlot software, a free to download data visualisation tool, can be used to analyse the data generated and create an ECG plot.

Fits the popular mikroBUS™ socket
7-block design (protection, preamplifier, high-pass filter #1, amplifier, high-pass filter #2, low-pass filter, DRL circuit)
Jumpers for setting output voltage range
Trimmer potentiometer to adjust gain
MCP609 Op Amp
MAX6106 Voltage Reference IC
ESD, Overvoltage and Overcurrent protection
Analogue output (mikroBUS™ AN pin)
5 V power supply

1 x ECG Click Board
1 x 3 Lead ECG Cable with 3.5mm Jack
30 x Single Use ECG Electrodes

The ECG Click Board is available as a separate item, MikroElektronika part MIKROE-2455.
The target board requires an MCU with a minimum 10-bit ADC.
Click board comes with the header strips soldered.

Click mikroBUS™ Biomedical Boards