Rugged current clamp adaptor suitable for use with multimeters to give non intrusive measurement of d.c. and a.c. current. Integral 1.2m 4mm shrouded plug lead.

Jaws accept conductor size of 1 x 30mm or 2 x 25mm dia.
d.c. current zero control for nulling out jaw/sensor offset
Superior noise immunity allows measurement in electrically noisy environments, such as adjustable speed drive line-side and load currents
Shielded, heat-resistant silicon rubber cable connects clamp to digital multimeter
Battery check mode
Compatible with meter input impedance ≥1MΩ
Conforms to IEC 1010-1 Cat III 600V

Supplied With: 9V PP3 alkaline battery and operators manual.

Use this current clamp from FLUKE when you need to measure flow without breaking a circuit. Wide jaws allow you to clamp the device over conductor diameters up to 30mm. Marks on each jaw arm help you reliably centre the conductor. A quick press of the lever opens and closes the jaws, so you can use the clamp one-handed for convenience. The 1.6m cable length means you'll have no problem reaching into awkward spaces.

• Hall-effect probe provides accurate readings from AC and DC circuits
• CAT III 600V safety category rating means it's safe to use on high-power busbars and distribution circuits
• Shrouded banana plugs protect you from shocks
• 60h battery life for dependability

• Automotive industry
• Medical equipment
• Telecommunications networks
• Consumer electronics
• Power distribution

This clamp measures DC currents between 1 and 1000A and AC currents between 1 and 600A, making it suitable for domestic and industrial circuits.

The product works with FLUKE multimeters, 120B series oscilloscopes and process meters. This includes the 125B scopemeter (919-5065), 789 series loop calibrator (449-4982) and 175 digital handheld multimeter (394-8826).