Crimp Tool Positioners | RS
Login / Register to access your benefits
Recently searched

    Crimp Tool Positioners, Turrets & Locators

    Crimp Tool Positioners are parts of a Crimping tool designed to adapt the tool frame to a particular application. Available in a wide selection of sizes and shapes locators guarantee versatility of every crimping tool. The data plate on each positioner designates which contacts the positioner accommodates for its wire size and indicates selector position. The positioners are easy to remove and replace when different connector size is required.

    How easy crimping tools and positioners, turrets and locators are to use?

    They are very easy to use, insert the contact pin into the hole of the crimp tool, load the wire into the contact pin, make sure it's fully seated then and squeeze until the cycle finishes then finally check that you have a secure crimp.

    How do you maintain the product?

    There is very little maintenance required for this tool, keep the indenter tips free of debris and dirt.

    The Importance of a High-Quality Crimp

    When a crimping tool is used on a terminal, two crimps take place at the same time. One is the electrical connection between the conductor and the terminal. The other is the insulation crimp which provides strain relief against vibration and tension.The electrical connection must be gas-tight without any voids between the wire strands and the terminal. If there are any voids present, then corrosion can occur causing resistance and excessive heat which damages the electrical connection. Using a good quality crimping tool will ensure that a full, gas-tight crimp is produced preventing future deterioration of the electrical connection and insulation breakage.

    178 Products showing for Crimp Tool Positioners, Turrets & Locators

    RS PRO
    Positioner
    QM/TNM
    16
    TE Connectivity
    Positioner
    AMP
    -
    Daniels Manufacturing
    Gauges
    M22520/3-1
    -
    Astro Tool Corp
    Insert
    MIL-DTL-38999 Series 3
    -
    TE Connectivity
    Plug Gauge
    -
    -
    HARTING
    Positioner
    Har-Speed
    -
    Glenair
    Positioner
    M22520/2-09
    -
    TE Connectivity
    Plug Gauge
    -
    -
    ITT Cannon
    Locator
    Trident
    -
    LEMO
    Positioner
    M
    -
    Daniels Manufacturing
    Positioner
    AS
    -
    Daniels Manufacturing
    Turret
    M22520/1-04
    -
    HARTING
    Positioner
    -
    -
    Staubli
    Locator
    MES-CZ
    -
    HARWIN
    Positioner
    -
    1
    HARTING
    Positioner
    D-sub
    -
    Phoenix Contact
    Assembly Tool
    SACC BIT M8-D12
    -
    Daniels Manufacturing
    Crimping Tool
    M22520/1-05
    -
    Bulgin
    Positioner
    6000
    8
    Phoenix Contact
    Assembly Tool
    SAC BIT M12-D15
    -
    Results per page