The Parallax motor mount is the wheel kit for the other two kits. This motor is the aluminium version so it provides a toughened chassis over the plastic. It can hold a total of 27kg with rugged tyres. Two independent motors drive the wheels so you can get the odometry feedback of your choice.

The Arlo robot is a mobile robot design to carry payloads. It is an indoor robot and uses a microcontroller for control. It is highly customizable with sensors and computers.

• Aluminium makes for a tough chassis with an increased payload support.
• 36-step optical slotted disk with quadrature output on each axle.
• Rugged inner-tubed tyres pneumatic tyres
• Maximum payload of 27KG
• Torque of 85lbs per motor assembly
• Wheel rotation with no load: 100rpm

• Two 12 VDC Motors. (Left & Right)
• 36 Position quadrature encoder set
• Two motor bearing blocks.
• Two Main rims
• Two rim rings
• Two robot drive axle’s
• Two 1/8 x 1” Roll Pink
• Two Knobby tires with rubber tube
• Two 0.5 ID x 1.125” OD Ball Bearing
• Two Hex keys (5mm & 5/32”)
• All screws and spacers.

This is only the wheel kit, to have a fully functioning robot you will need the below kits.
Base Kit: 8430822
Top Kit: 8430796

All necessary screws and spacers

The Arlo Robotic System provides the basic hardware to build a mid-size robotics platform ideal for telepresence and autonomous robots. The format is one of a two-wheeled buggy with castors fore and aft. The user can then attach the processor board, motor control boards and sensor/actuator modules to suit their application.