Weller XNT CC 3.2 mm Bevel 28 mm Soldering Iron Tip for use with WXP65, WXP90, WTP90, WP65

This soldering iron tip is a bevel-shaped replacement element designed for precision thermal work with compatible Weller handpieces. It provides a defined contact angle for controlled heat transfer and is intended for use with specific soldering stations in electronics maintenance and assembly environments.

• 45° bevel delivers controlled contact for precise joints
• 3.2mm tip width concentrates heat for small pads
• 28mm length offers extended reach into confined areas
• UPC approval confirms standardised manufacturing oversight
• Compatible with multiple Weller iron types for swap-in replacement

• Suitable for delicate SMD rework where angled access is required
• Ideal for general-purpose through-hole soldering on PCBs
• Used with WXP65-compatible soldering tip setups
• Can be used for repair tasks on densely populated assemblies
• Used for maintenance of WTP90 replacement tip toolsets

It fits a selection of Weller handpieces designed for replaceable tips, enabling use on models that accept exchangeable XNT-format ends.

The angled face improves visibility and allows lateral heat transfer, aiding in controlled wetting of component leads and pads.

The length and slim profile permit access into narrow spaces while maintaining steady thermal contact.

Ensure the iron is powered down and cooled, then match the tip geometry and width for consistent thermal performance during reinstallation.

Weller recommends the use of Weller-branded solder wire (WSW) to achieve the best soldering performance and maximise the service life of your Weller soldering products.