Metcal SSC 1.5 mm Chisel 10 mm Soldering Iron Tip for use with MFR-H6-SSC, SP-HC1

This soldering iron tip is a chisel-shaped replacement intended for precision soldering in electronics repair and assembly environments where controlled heat transfer is required. It is designed to Interface with compatible soldering handles and provides a focused contact profile for wetting and forming solder joints in confined areas.

• Chisel geometry delivers consistent wetting and controlled solder flow
• 30° tip angle enables access to angled joints and leads
• 10mm length supports repeatable thermal contact depth
• RoHS compliance ensures absence of restricted substances
• 1.5mm tip width permits fine work on small pads and leads

• Suitable for repair of small electronic components and leads
• Used with compatible handles for repetitive soldering tasks
• Ideal for forming fillets on plated through-holes and pads
• Can be used for delicate rework on tight component clusters

It is designed to fit specific handles that accept the same chisel-style connection and thermal transfer interface.

The 30° angle concentrates contact area for efficient heat transfer to narrow joint geometries while allowing lateral access.

The 1.5mm width is intended for small pads, narrow leads and detail soldering where precision is required.

A 10mm length provides stable thermal mass and consistent penetration into joint areas without excessive overhang.