Ruland Oldham, 57.2mm Outside Diameter, 17mm Bore, 78.7mm Length Flexible Coupling

Platform Cable USB II configures Xilinx FPGAs, programs Xilinx PROMs and CPLDs and directly programs third-party SPI Flash memory devices.

Programs and configures all Xilinx devices:
XC18V00 ISP PROMs
Platform Flash XCF00S/XCF00P/XL PROMs
All UltraScale, 7 series, Virtex and Spartan FPGA families
All Zynq-7000 AP Systems-on-Chip
XC9500XL and CoolRunner XPLA3/CoolRunner-II CPLDs
Supports JTAG and Slave-Serial programming topologies
Firmware downloadable over cable
Fully integrated and optimised for use with Xilinx iMPACT software (required for programming and configuration)
Intuitive multiple cable management from a single application
Compatible with Windows and Linux operating systems
Automatically senses and adapts to target I/O voltage
Interfaces to devices operating at +5 V (TTL), +3.3 V (LVCMOS), +2.5 V, +1.8 V and +1.5 V
Powered from USB connection
Target power status LED
Firmware updates are transparent to the user
Highly optimised for use with Xilinx design tools: ISE Foundation Software, Embedded Development Kit, ChipScope Pro Analyser and System Generator for DSP

The Ruland Clamp Oldham Coupling Hub is a component of a three-piece design consisting of two anodized aluminum hubs press-fit onto a center disk. This design allows for a highly customizable coupling that easily combines clamp or set screw hubs with inch, metric, keyed, and keyless bores. Disks are available in three materials, enabling users to tailor performance to their specific application. It can accommodate all forms of misalignment and is especially effective in applications with high parallel misalignment (up to 10% of the OD).

Balanced design for reduced vibration at high speeds
Operates with low bearing loads protecting sensitive system components such as bearings
Machined from bar stock that is sourced exclusively from North American mills
RoHS compliant
REACH compliant
Zero backlash

Programmable Logic Programming