These accessories are for use with this range of Push-In Terminal Blocks.

Thanks to this jumper bar from Phoenix Contact, linking terminal blocks couldn't be easier. It simply plugs into the front of your blocks, meaning there's no need to strip wires or find special tools. This makes it quick and easy to install and enables you to swiftly adapt systems.
The cover insulates the conductors, so it's reliably safe to use. This also acts as a stop, so you know when the bar's fully pushed in. As it's red, you'll have no trouble spotting your connections on busy marshalling panels and distribution boards.
There are three prongs to bridge between multiple blocks. These are made from conductive copper to ensure your circuits are dependable. A pitch of 5.2mm means this jumper bar works with standard blocks, including feed-through, disconnect and pluggable terminals commonly used in automated setups.

• Current rating of 24A for use in high-power systems
• Flame-retardant material means burning stops in 10 seconds to boost fire safety
• Polyamide cover is resistant to wear and impact to give you a strong connection
• Middle prong is removable, so you can bridge non-adjacent terminal blocks

Push-In Connection Terminal Blocks

The PT series is characterised by easy, direct conductor connection, and it consistently uses the advantages of the CLIPLINE complete system. The up to 50% lower insertion forces of the PT push-in connection method also allows easy and direct plugging of solid and stranded conductors with ferrules of 0.34mm² and up.