The i30 may be used in conjunction with multimeters, recorders and other suitable recording instruments for accurate non-intrusive ac & dc current measurement.,Applications include: inverters, switch mode power supplies, industrial controllers, automotive leakage currents and other applications requiring accurate isolated current measurement.

Hall effect sensing of a.c. and d.c. current
Power LED warns of low battery by flashing
Zero adjust knob to accommodate offsets
1.5m flying lead terminated with 4mm shrouded plugs
Designed to meet EN61010-1, EN61010-2-032 installation CAT III 300V
Withstands overloads to 500A

Use of the probe on uninsulated conductors is limited to 300V ac rms or dc and frequencies below 1 kHz.

Alkaline PP3 battery and operators manual.

Need to pinpoint AC and DC currents inside set parameters? Use this current clamp from FLUKE with your digital multimeters to get precise isolated readings and limit system downtime. You can rely on the unit's integrated Hall-effect technology for reliable accuracy over wide ranges. It also curbs power consumption to stretch the battery life to 30 hours. As a CAT III-approved device, you can be sure this current clamp meets safety standards for 3-phase distribution systems, so you don't have to worry about getting a shock.

• 1.5m cable length for easy reach
• Extensive operating temperature range between 0°C and +50°C for use in tough conditions

• Switch-mode power supplies
• Industrial controllers
• Medical equipment
• Automotive industry

A flashing LED grabs your attention to let you know it's time for a recharge.

The item is a probe that clamps around a conductor to measure AC or DC currents. This means you can safely go ahead with a job without breaking circuits.