Texas Instruments USB Development Kit TMDX5535EZDSP

Technical Reference
Legislation and Compliance
RoHS Certificate of Compliance
Product Details

C5535 EzDSP USB Stick Development Kit

Texas Instruments TMDX5535eZdsp is a small form factor and a low cost USB-powered DSP development kit. This includes all the hardware and software needed to evaluate the TI C553x generation of processors with lowest power 16-bit DSP. The kit has an on-board XDS100 emulator for a full course-level debug capability and supports Code Composer Studio™ (CCStudio) Integrated Development Environment (IDE) version 4x and eXpressDSP™ software which includes the DSP/BIOS™ kernel.

Small form factor DSP development kit for the C5535 processor
TMS320C5535 fixed point ultra-low-power DSP
Embedded XDS100 emulator
USB 2.0 high speed
Micro SD card slot with 2-GB micro SD card
Line In/Mic in, headphone out audio jacks
60-pin expansion connector
96 x 16-pixel OLED display
Includes Code Composer Studio IDE 4.x
Software framework for USB audio class and HID applications
Out-of-the-box demo software
Full documentation with source code on CD-ROM
Software

Digital Signal Processors, Texas Instruments

Specifications
Attribute Value
Classification Development Kit
Technology USB
36 In stock for FREE next working day delivery
Price Each
£ 235.18
(exc. VAT)
£ 282.22
(inc. VAT)
Units
Per unit
1 +
£235.18
Due to temporarily constrained supply, RS is unable to accept backorders at this time
Related Products
The Pmod DA2 is a dual 12-bit Digital-to-Analogue ...
Description:
The Pmod DA2 is a dual 12-bit Digital-to-Analogue converter module featuring the Texas Instruments DAC121S101 device. • 2 x simultaneous conversion channels• Settling time: 8μs• Power down mode• Host communication: serial• 6-pin Pmod connector with GPIO interface• Dimensions: 25 x 20mm.
The Pmod ISNS20 is a small current measuring ...
Description:
The Pmod ISNS20 is a small current measuring module based on an Allegro ACS722 Hall Effect current sensor with an ADCS7476 12-bit ADC from Texas Instruments. • Measurement range: ±20A AC/DC• Accuracy: ±2%• Jumper-selected sampling rates: 120Hz, 20kHz or 80kHz• 6-pin Pmod connector with SPI interface• Follows Digilent Pmod Interface ...
ccRF 3 click carries the CC1120 high-performance RF ...
Description:
ccRF 3 click carries the CC1120 high-performance RF transceiver for narrowband systems from Texas Instruments. The clicks will enable you to add a low-power consumption radio transceiver at 433 MHz frequency. ccRF 3 click is designed to run on a 3.3V power supply. It communicates with the target microcontroller over ...
RS485 3 click uses SN65HVD31DR from Texas Instruments, ...
Description:
RS485 3 click uses SN65HVD31DR from Texas Instruments, a tri-state differential line driver and differential input line receiver. The click is intended to be used as UART to RS422/RS485 communication interface. It is suited for transmitting smaller blocks of data over long distances, using the four-wire bus, allowing for full-duplex ...