- RS Stock No.:
- 131-1336
- Mfr. Part No.:
- 8.07.01 SWD Isolator
- Brand:
- SEGGER
- RS Stock No.:
- 131-1336
- Mfr. Part No.:
- 8.07.01 SWD Isolator
- Brand:
- SEGGER
Technical Reference
Legislation and Compliance
Product Details
J-Link ARM SWD Isolator Board
The J-Link SWD Isolator can be connected between a J-Link Probe and an ARM-board with a 20-pin debug connector to provide electrical isolation. This is essential when the development tools are not connected to the same ground as the application.
Compatible Probes
J-Link BASE 131-1319, J-Link PRO, J-Link ULTRA+, J-Link PLUS, Flasher ARM
Features
1kV DC optical isolation
+3.3V and +5Vdc target operation supported
Powered from probe and target
SWD 20-pin connection with SWCLK, SWDIO, SWO and RESET signals
Power consumption on target side: 25mA typical
SWD frequency: Up to 4MHz
3 x LEDs: Probe Power, Target Power and Target RESET
+3.3V and +5Vdc target operation supported
Powered from probe and target
SWD 20-pin connection with SWCLK, SWDIO, SWO and RESET signals
Power consumption on target side: 25mA typical
SWD frequency: Up to 4MHz
3 x LEDs: Probe Power, Target Power and Target RESET
Specifications
Attribute | Value |
---|---|
Accessory Type | Adapter |
For Use With | J-Link Probes |
Related links
- SEGGER 8.06.16 J-Link 6-pin Needle Adapter Adapter for use with J-Link
- SEGGER 8.06.10 J-Link RX FINE Adapter Adapter
- SEGGER for J-Link Probes 8.07.02 USB Isolator
- SEGGER 8.06.19 J-Link Xilinx Adapter Adapter
- SEGGER 8.06.00 J-Link 19-Pin Cortex M Adapter for use with J-Link Probes
- SEGGER 8.06.12 J-Link Signal Smoothing Adapter Adapter for use...
- SEGGER 8.08.01 J-Link ARM-14 Adapter for use with J-Link Probes
- SEGGER 8.06.02 J-Link 9-Pin Cortex M Adapter for use with J-Link Probes