ON Semiconductor BLDC-GEVK Internet of Things (IOT) BLDC Motor Driver Shield Evaluation Kit BLDC Evaluation Kit for

Technical Reference
Legislation and Compliance
RoHS Certificate of Compliance
Product Details

ON Semiconductor Evaluation Board

The ON Semiconductor evaluation board is an internet of things motor driver shield evaluation board. It comes with LV8907, high performance, sensor-less three-phase BLDC motor controller with integrated gate drivers for driving external N-MOSFETs. An on-chip two-stage charge pump provides the required gate current for a wide range of ultra-low RDS(ON) type external N-MOSFETs. This is applicable for three-phase BLDC motor driver.

Features and Benefits:

• A watchdog timer
• An in-built linear regulator for powering an external circuit
• An SPI interface is provided for parameter setting and monitoring the system health and utilized through the PCA9655E's 16 bits of general purpose parallel input and output (GPIO) expansion
• Local interconnect network (LIN) transceiver
• Supports open-loop, as well as, closed-loop speed control with user configurable start up, speed setting and proportional/integral (PI) control coefficients
• System protection and diagnostic functions such as over-current, over-voltage, short-circuit, under-voltage and over-temperature

Specifications
Attribute Value
Kit Name Internet of Things (IOT) BLDC Motor Driver Shield Evaluation Kit
Kit Classification Evaluation Kit
For Use With Three-Phase BLDC Motor Driver
Motor Type BLDC
Featured Device LV8907UWR2G, MBRB40250TG, MM3Z39VT1G, MMDL6050T1G, NTMFS5C404NLTT3G, PCA9655EMTTXG
2 In stock for FREE next working day delivery
Price Each
£ 33.66
(exc. VAT)
£ 40.39
(inc. VAT)
Units
Per unit
1 +
£33.66
Related Products
The Korg Nutube HA-E1 electronic part kit of ...
Description:
The Korg Nutube HA-E1 electronic part kit of headphone amplifier contains the components to be assembled on the main circuit board. This kit includes slide switch, trimmer potentiometers, volume control, resistors, capacitors, IC socket, operational amplifiers (NJM4580 and MUSES01), battery box, connector, stereo mini-phone jacks, hardware and harness. • ANSI/ESD ...
The P-NUCLEO-6180X1 is an evaluation pack that provides ...
Description:
The P-NUCLEO-6180X1 is an evaluation pack that provides an introduction to the proximity, ranging and light sensing capabilities of the VL6180X sensor, combined with the powerful STM32F401RE microcontroller.The expansion board features the VL6180X, a Proximity sensor, gesture and Ambient Light Sensing (ALS) module. The VL6180X is based on STMicroelectronics Flight ...
The HFBR-0528Z kit from Avago Technologies, facilitates the ...
Description:
The HFBR-0528Z kit from Avago Technologies, facilitates the evaluation of DC to 10MBd high performance 650nm transmitter HFBR-1528Z and receiver HFBR-2528Z (stock no. 236-846). Fitted with SMA connectors, the HFBR-0528Z evaluation board makes it easy to connect a waveform/pattern generator to the TX and to monitor the RX output with ...
The Click accessory modules plug into the Mikro ...
Description:
The Click accessory modules plug into the Mikro BUS sockets in Mikro Elektronika microcontroller development boards. DC MOTOR click provides full H-Bridge control for a small DC motor. DRV8833RTY H-Bridge motor driver chip Speed controlled by PWM signal Two signals provide direction and brake/coast control Motor current sensing resistor Max ...