Fluke I30S Current Probe & Clamp

  • RS Stock No. 645-1836
  • Mfr. Part No. I30S
  • Brand Fluke
Technical Reference
Legislation and Compliance
RoHS Status: Not Applicable
COO (Country of Origin): CN
Product Details

Fluke Current Probe & Clamp

The Fluke 2m AC or DC current clamp is a new age device used with oscilloscopes and DMMs for accurate, non-intrusive measurement of both AC, DC and complex waveform currents. Using advanced Hall Effect technology, the i30s can accurately measure currents with a resolution of 1mA from 5mA to 30A over the frequency range of DC to 100kHz.
Inclusions:
Alkaline PP3 battery, 4mm shrouded plug adaptor and an operator’s manual.
Warning:
Use of the probe on uninsulated conductors is limited to 300VAC RMS or DC and frequencies below 1kHz.

Features and Benefits

Power LED warns of low battery by flashing
Accuracy of 1% + 2mA
Zero adjust knob to accommodate offsets
The wide, flat frequency response means this probe exhibits a fast response when measuring current pulses
2.0m flying lead terminated with 50Ω BNC plugs
Withstands overloads to 500A

Applications

Inverters
Switch mode power supplies Industrial controllers
Automotive leakage currents
Applications requiring accurate isolated current measurement
Waveform analysis

Certifications

CAT III 300V
ICE 61010-1
Pollution degree 2
IEC 61010-2-032

Specifications
Attribute Value
Current 30A
Probe Type AC/DC
Minimum Bandwidth 0Hz
Maximum Bandwidth 100kHz
Maximum Conductor Size 19mm
Safety Category CAT III 300 V
Safety Category Level CAT III
Model Number p I30S
Best Accuracy ±1% + 2 mA
Safety Category Voltage 300V
Bandwidth DC → 100 kHz
16 In stock - FREE next working day delivery available
Price Each
£ 519.00
(exc. VAT)
£ 622.80
(inc. VAT)
Units
Per unit
1 +
£519.00
Calibration Options:
Related Products
The Fluke power quality clamp meter is the ...
Description:
The Fluke power quality clamp meter is the ideal meter for commissioning and troubleshooting modern electrical loads. With a bright colour display to analyse the harmonic spectrum, a low-pass filter to remove high-frequency noise, and a high EMC immunity design, the Fluke 345 is ideal for measurements on switching loads ...
The F65 clamp-on meter is the ideal tool ...
Description:
The F65 clamp-on meter is the ideal tool for detecting insulation faults and inadvertent tripping of differential circuit breakers caused by current leakages.It also provides all the functions of a clamp-on multimeter.Supplied with one set of 4 mm R / N angled leads with 4 mm touch probes, a set ...
Keysight U1190 Series clampmeters are built to perform ...
Description:
Keysight U1190 Series clampmeters are built to perform in the environments that users work in. Current measurement is up to an impressive 600A. These instruments are ergonomically designed to fit comfortably in the palm of the hand and allow selection of measurement functions with a simple thumb press. Unique wire ...
Dual range a.c. current clamp nominal measuring ranges ...
Description:
Dual range a.c. current clamp nominal measuring ranges 0.1A to 20A a.c. and 0.5A to 200A a.c.Safe, non intrusive current measurement40Hz to 10k Hz bandwidth Ergonomic jaw design for measurement where access is difficult and allows 'hooking' onto the cable Max. conductor size 20mm dia. or 20 x 5mm bus ...